REC-002563

active

0 NISSAN Pulsar, X-Trail

Category: Light Vehicle · Supplier: Nissan Motor Co (Australia Pty Ltd

Recall date: 3 November 2003

Defect

The circuit board for the crank position sensors may have an improper solder joint due to solder deformation caused by heat stress accelerated by the existence of flux residue during the soldering process. This could cause the 'service engine soon' warning to appear.

Hazard

Malfunction.

Remedy

Letters will be sent to all owners. For further information contact your authorised Nissan Dealer. Please note the recall will commence at the end of November. Nissan recommends owners drive vehicles with caution until rectified.

What should you do?

Check your VIN below to confirm whether your specific vehicle is affected.
Contact the supplier — Nissan Motor Co (Australia Pty Ltd — or your nearest authorised dealer to arrange the recall remedy.
Recall repairs are free of charge. The manufacturer or supplier is legally required to fix the defect at no cost to you.
If you have difficulty getting the recall addressed, contact the Department of Infrastructure or your state's consumer protection agency.

Check Your VIN

Enter your Vehicle Identification Number to check if your specific vehicle is affected by this recall.

Source: https://www.vehiclerecalls.gov.au/recalls/rec-002563

Continue browsing

Explore more vehicle recalls or run a broader search across all sources.

Browse Vehicle recalls Search all recalls