REC-002896

active

0 Toyota ECHO (NCP1#) & PRIUS (NHW11)

Category: Light Vehicle · Supplier: Toyota Motor Corporation Australia Limited

Recall date: 19 July 2006

Defect

Due to improper moulding of the resin body of the crankshaft position sensor installed on the engine block, engine oil may penetrate the seal and enter the sensor wiring connector. In addition, the wire harness connector may not be sufficiently attached to the locking tab of the sensor wiring connection. In this condition, engine oil inside the sensor wiring connector could cause expansion due to the heat of the engine and could deform the sensor wiring connector. In the worst case, the connector may become disconnected, which could cause the engine to stall while driving and not be able to be restarted.

Hazard

Road accident resulting in death or serious injury.

Remedy

Contact your local Toyota dealer.

What should you do?

Check your VIN below to confirm whether your specific vehicle is affected.
Contact the supplier — Toyota Motor Corporation Australia Limited — or your nearest authorised dealer to arrange the recall remedy.
Recall repairs are free of charge. The manufacturer or supplier is legally required to fix the defect at no cost to you.
If you have difficulty getting the recall addressed, contact the Department of Infrastructure or your state's consumer protection agency.

Check Your VIN

Enter your Vehicle Identification Number to check if your specific vehicle is affected by this recall.

Source: https://www.vehiclerecalls.gov.au/recalls/rec-002896

Continue browsing

Explore more vehicle recalls or run a broader search across all sources.

Browse Vehicle recalls Search all recalls